-
HEART OF HAPPY HOMES
-
5 MILLION HAPPY HOMES
-
SUBMERSIBLE PUMPS FOR DIVERSIFIED UTILITY
- All pumps are only suitable for pumping clear, cold non aggressive, non explosive water without abrasives, solid particles or fibres.
- Check the water level in deepwell submersible and openwell submersible pumpsets as detailed given in operator’s manual before commissioning.
- The Performance data and rated voltage are only indicative, actual discharge depends on availability of water in well, based on strength of water source, height of water column, submergence of pump.
- Performance applicable to liquid of specific gravity and viscosity as of water.
- Friction losses in riser pipe have not been calculated.
- Pump should not be operated dry. Install dry run preventer to protect the pumpset from dry running.
- Pump should be run for few minutes atleast once in 2 days to prevent from seizing.
- Performance applicable to 3 mtr submergence of pump unit in water.
- To get better performance, install the pumpset between 50% to 80% of its total head capacity.
- Maximum permissible supply voltage should between- 15% to +6%.
- All pumps employ a prime mover motor suitable for 200 – 240 Volts single phase or 380-415 Volts three phase, 50 Hz, Ac Supply.
- Use appropriate size, good quality cable as per cable section chart and starter / protection devices.
- Avoid fatal electrical shock or injury by disconnecting power before working on or around the pumping system.
- Only technically qualified personnel must perform the works complying with Local electricity rules and regulations.
- To reduce the risk of electrical shock during operation an appropriate earthing is mandatory.
- The pipe diameters must never be smaller than the pump connections.
- Reduce number of bends, elbows, T-bends as much as possible in the pipe tine.
- Use ISI marked and low friction good quality pipes.
- Use Air valves in lengthy delivery pipe line to avoid pipe damage.
- Read our operators manual carefully before installation.